crypto: stm32/cryp - enable for use with Ux500

This adds a few small quirks to handle the differences between
the STM32 and Ux500 cryp blocks. The following differences
are handled with special bool switch bits in the capabilities:

- The main difference is that some registers are removed, so we
  add register offsets for all registers in the
  per-variant data. Then we assign the right offsets for Ux500
  vs the STM32 variants.

- The Ux500 does not support the aeads algorithms; gcm(aes)
  and ccm(aes). Avoid registering them when running on Ux500.

- The Ux500 has a special "linear" key format and does some
  elaborare bit swizzling of the key bits before writing them
  into the key registers. This is written as an "application
  note" inside the DB8500 design specification, and seems to
  be the result of some mishap when assigning the data lines
  to register bits. (STM32 has clearly fixed this.)

- The Ux500 does not have the KP "key prepare" bit in the
  CR register. Instead, we need to set the KSE bit,
  "key schedule encryption" bit which does the same thing
  but is in bit 11 rather than being a special "algorithm
  type" as on STM32. The algorithm must however be specified
  as AES ECB while doing this.

- The Ux500 cannot just read out IV registers, we need to
  set the KEYRDEN "key read enable" bit, as this protects
  not just the key but also the IV from being read out.
  Enable this bit before reading out the IV and disable it
  afterwards.

Cc: Maxime Coquelin <[email protected]>
Cc: Alexandre Torgue <[email protected]>
Acked by: Lionel Debieve <[email protected]>
Signed-off-by: Linus Walleij <[email protected]>
Signed-off-by: Herbert Xu <[email protected]>

Author: linusw