iommu: Add a page fault handler

Some systems allow devices to handle I/O Page Faults in the core mm. For
example systems implementing the PCIe PRI extension or Arm SMMU stall
model. Infrastructure for reporting these recoverable page faults was
added to the IOMMU core by commit 0c830e6 ("iommu: Introduce device
fault report API"). Add a page fault handler for host SVA.

IOMMU driver can now instantiate several fault workqueues and link them
to IOPF-capable devices. Drivers can choose between a single global
workqueue, one per IOMMU device, one per low-level fault queue, one per
domain, etc.

When it receives a fault event, most commonly in an IRQ handler, the
IOMMU driver reports the fault using iommu_report_device_fault(), which
calls the registered handler. The page fault handler then calls the mm
fault handler, and reports either success or failure with
iommu_page_response(). After the handler succeeds, the hardware retries
the access.

The iopf_param pointer could be embedded into iommu_fault_param. But
putting iopf_param into the iommu_param structure allows us not to care
about ordering between calls to iopf_queue_add_device() and
iommu_register_device_fault_handler().

Tested-by: Lu Baolu <[email protected]>
Reviewed-by: Eric Auger <[email protected]>
Reviewed-by: Jacob Pan <[email protected]>
Reviewed-by: Jonathan Cameron <[email protected]>
Reviewed-by: Lu Baolu <[email protected]>
Signed-off-by: Jean-Philippe Brucker <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Joerg Roedel <[email protected]>

Author: jpbrucker

drivers/iommu/Makefile

@@ -28,3 +28,4 @@ obj-$(CONFIG_S390_IOMMU) += s390-iommu.o
 obj-$(CONFIG_HYPERV_IOMMU) += hyperv-iommu.o
 obj-$(CONFIG_VIRTIO_IOMMU) += virtio-iommu.o
 obj-$(CONFIG_IOMMU_SVA_LIB) += iommu-sva-lib.o
+obj-$(CONFIG_IOMMU_SVA_LIB) += io-pgfault.o