forked from arduino/Arduino
-
Notifications
You must be signed in to change notification settings - Fork 5
How to drive the board's port output to 3.3V
MikiyaKobayashi edited this page May 10, 2024
·
2 revisions
- The default drive voltage of the RL78 Fast Prototyping Board is 5V.
- Is it possible to change to 3.3V drive?
- You can change the drive voltage by changing the jumper settings on the power selection header.
- Please download the manual for each FPB from List of Supported Boards.
- Please check the "Power-Supply Selection Header" chapter in the manual and change jumper settings if necessary.